Fldigi baofeng11/9/2023 Make sure the computer detects the interface. If you worked digital modes with another interface then start with restoring that setup first – most transceiver settings will carry over. Last change that breaks things is your culprit. Rollback to what works: if something worked before and after multiple changes it doesn’t, then try restoring working configuration and make changes one-at-a-time. My go-to choice is WSJT-X configured to directly control the radio. Disconnect any non-essential hardware (amps, tuners etc.) from your transceiver and start with the most generic software package. Don’t attempt debugging the hardware while also trying to configure a dozen configuration screens you have never seen before. Simplify and isolate: when something doesn’t work, try narrowing down your experimentation scope to a single concern. This list is the summary of the technical support solutions I provided via the email and in the user groups over the recent months. Some solutions are specific to Digirig, but most are applicable to other interfaces. Here we’ll look at the ways to troubleshoot various issues related to setting up ham radio’s digital modes. With this I used my day’s allowance of idioms, moving on… It also leaves plenty of room for things to not work out-of-the-box. Such complexity makes this hobby a delightful bottomless pit of learning. There is no shortage of complexity in radio even before we add computers. Digirig is often described as turnkey, just works and plug-n-play, however your mileage may vary.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |